Instructions to Apply Rhinestone Iron On Transfer Motifs

Instructions to Apply Rhinestone Iron On Transfer Motifs
Item# iron-on-rhinestone-instructions
Availability: Usually ships in 5-7 business days
This item is currently out of stock!

Product Description

Instructions to apply rhinestone motifs via home iron:

1. Preheat iron to the hottest setting (usually cotton setting).

2. Prepare on a HARD, flat surface such as a table or dresser top (do not press the rhinestone motif on an ironing board or other padded surface.)

3. Carefully remove the textured white paper backing and place the motif on the garment or item.

Note: the stones will be sticking to the clear plastic sheet. If any stones have shifted out of place, use tweezers to reposition them if needed.

4. Place the sticky side of the clear plastic sheet, rhinestone side down, on the right side of the fabric and press the design into place with your hand. The clear plastic sheet will adhere to the fabric. If you need to re-adjust, pick it up completely and place it down again. Do NOT slide it back and forth into place.

5. Press the motif with the iron with stiff pressure for 20 to 25 seconds. If the motif is larger than the iron, repeat until the entire motif has been heated.

6. Allow to cool and when clear film is cool to the touch, gently peel the clear film from your garment or item. Run your finger nails across the stones to ensure they stay put. If any stones are loose or if some of the stones did not adhere, replace the paper and repeat step 5 and re-press.



Instructions to apply rhinestone motifs via Heat Press:

1. Heat to 350 degrees.

2. Carefully remove the textured white paper backing and place the motif on the garment or item.

Note: the stones will be sticking to the clear plastic sheet. If any stones have shifted out of place, use tweezers to reposition them if needed.

3. Place the sticky side of the clear plastic sheet, rhinestone side down, on the right side of the fabric and press the design into place with your hand. The clear plastic sheet will adhere to the fabric. If you need to re-adjust, pick it up completely and place it down again. Do NOT slide it back and forth into place.

4. Press the motif at 350 degrees with “medium to firm” pressure for 10-15 seconds.

5. Allow to cool and when clear film is cool to the touch, gently peel the clear film from your garment or item. Run your finger nails across the stones to ensure they stay put.





Fabrics that May or May Not Be Used:

*YES: cottons, cotton blends, polyester, wool, silk, velveteen, velour, and denim (the softer the better). T-shirts and sweatshirts are probably your easiest fabrics; lycra, cotton sweaters are easiest. Always test fabrics if you're not sure, read the garment manufacturer’s hang tag for ironing instructions.

*NO: nylon jackets, velvet, acrylic, leather, vinyl, and trigger (fabrics with a finish). Always test fabrics if you're not sure, read the manufacturer’s garment hang tag for ironing instructions.

Disclaimer: due to the variance of fabric, methods of application, and other circumstances beyond our control, the customer assumes all risk related to the use of our products.